Get some peace of mind with the Honeywell RWD4IT Home Water-Sensing Alarm. This Honeywell Water Alarm comes with a six foot leader cable and a four foot water sensing cable. The entire cable will detect water, giving you more covered area. The patented cable solution extends the water detection zone as well. The existing cable is capable of being expanded up to 250 feet. This is enough cable to go around the entire perimeter of many basements. The Honeywell Water Sensor is powered by a 9-volt battery, and the system has a chirp alert for when the battery is getting low. The audible alarm will let you know when the cable detects water. This sensor helps ensure water does not get into your basement without you knowing. Place it in areas that are hard to see, or where water would not be immediately noticed.
I looked at this device through many sites and decided to buy through WAL-MART because it said it had 16 ft of wire. There is only as much wire as offered by anyone else and no more! It had about 8 feet of wire and the detection wire was about 6 feet making about 14 feet total. You can easily extend the length of the wire with any length of common phone cord you may have laying around, but you must purchase an adapter to join the male ends. This adapter can be found anywhere wired phones are sold for 5-8 dollars. Works well if you can get device in hearing range.
Recommends this product? Yes
Age:45 - 54
Ownership:2 - 7 weeks
Share this review:
Thank you! You have successfully submitted a comment for this review.