The XPTH 9 HDSI 180 T 710210-1 Humminbird Thru Hull Transducer helps you to locate the fish and determine the depth of water by sending and receiving signals underneath the boat. This device is equipped with dual/high-definition side imaging, as well as a built-in temperature gauge and a shaft diameter of 1". This plastic marine transducer has four beam angles at 20, 60, 86 and 55 degrees and also has four frequency levels that include 200, 83, 455 and 800 kHz for high-definition imaging. This unit is compatible for use with a variety of SI boat models. The kit includes the transducer, all required mounting hardware, a 30' cable, a fairing block and a product manual. This Humminbird transducer is a handy piece of equipment that can benefit both beginning and advanced anglers.
This unit works well and avoids the interference that the transom mounted units have due to the beam hitting the motor. When you install the unit be sure that you choose a location that has line-of-sight for the beams at 90 degrees out from the bottom of your boat. The only downside is that the leveling block that is shipped with the unit is inadequate. It is made of rubber. When I took it to my local machine shop to have it cut to the correct angle they said that the material needed to be cryogenically frozen before they could get a clean cut. They do not do that kind of work. This is not a big deal because they have other materials at most machine shops that will work just as well. I would recommend this product for anyone that is using a side imaging sonar unit.
Recommends this product? Yes
Share this review:
Thank you! You have successfully submitted a comment for this review.
Review 2 for Humminbird Plastic Thru Hull Transducer XPTH 9 HDSI 180 T 710210-1